DIN3967f6S
DIN3967f6S
(OP)
I have recently purchased DIN3967 gear standards in order to try and get a handle on some gear specifications we already have with respect to determining backlash.
A number of drawings we have which have been specified by a designer who has now left the company state the following as the quality class.
DIN3967f6s.
From the din3967 standard i have tolerance allowance series for tooth thickness from a to h and backlash modification values for gear quality class from 1 to 12. These are tabulated with respect to reference diameter and module respectively.
My question is that the make of of the above reference i am making the assumption that the letter f is derived from the tooth thickness allowance series and the number 6 refers to the gear tooth quality class. However i cannot find in DIN3967 any reference to the letter s?
This may be something simple i am missing.
Any ideas.
Many Thanks
Gary
A number of drawings we have which have been specified by a designer who has now left the company state the following as the quality class.
DIN3967f6s.
From the din3967 standard i have tolerance allowance series for tooth thickness from a to h and backlash modification values for gear quality class from 1 to 12. These are tabulated with respect to reference diameter and module respectively.
My question is that the make of of the above reference i am making the assumption that the letter f is derived from the tooth thickness allowance series and the number 6 refers to the gear tooth quality class. However i cannot find in DIN3967 any reference to the letter s?
This may be something simple i am missing.
Any ideas.
Many Thanks
Gary





RE: DIN3967f6S
it does happen that the letter s is used for a symmetrically placed tolerance field in a DIN standard.
e.g. for shafts does excist j6 as well as js6.
knd regards,
Gerrit