Bend Info
Bend Info
(OP)
Greetings All
In wildfire 2 I would like to know if it is possible to get the required bend info and bend lines to appear automatically when the Flat Pattern view is created on a drawing similar to the way it does on Solidworks drawings?...
In wildfire 2 I would like to know if it is possible to get the required bend info and bend lines to appear automatically when the Flat Pattern view is created on a drawing similar to the way it does on Solidworks drawings?...





RE: Bend Info
Bend info can be created from the bend table.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
Sr IS Technologist
L-3 Communications
RE: Bend Info
Thanks for the info
Can you please elaborate? I have just started using Wildfire2 and will be atteding training next month...The person That I am replacing used to put all the info in manually and has mixed up bend directions on numerous occasions...Any help to automate the process would be highly appreciated as I do not want to follow in his footsteps...