NX4: Can't edit boundary of Break Out Section.
NX4: Can't edit boundary of Break Out Section.
(OP)
Break Out Section is a handy function, but I'm having difficulty moving or otherwise editing the boundary spline. I also tried to delete the break out, so as to make a new one, but I can't do that either. Does anyone here know how to change the boundary or edit it?
'ziner
Peace Through Superior Fire-Power!
'ziner
Peace Through Superior Fire-Power!





RE: NX4: Can't edit boundary of Break Out Section.
Now I'll admit that this is both non-standard and not very intuitive behavior, but that's the way it is, at least for the time being. And before anyone asks, this particular behavior has NOT changed in NX 5, but I'm sure that it's on the list for a future update.
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
http://www.siemens.com/ugs
http://www.plmworld.org/museum/