Lightweight in assemblies
Lightweight in assemblies
(OP)
When I open an assembly it always goes to lightweight. I have turned off the "Use large Assembly Mode" to increase performance. I do not have a check mark in the "Automatically load components lightweight" I have increased the number of components to 1500 in the "Use large assembly Mode".
If I rebuild after "Set Lightweight to resolved" and then save the assembly, when I re-open it it is back to lightweight.
Thanks in advance
Scott4tg
Solidworks 2006
If I rebuild after "Set Lightweight to resolved" and then save the assembly, when I re-open it it is back to lightweight.
Thanks in advance
Scott4tg
Solidworks 2006






RE: Lightweight in assemblies
In Tools > Options > System Options > Performance/Assemblies set Resolve lightweight components and Rebuild assemblies on load to Always
RE: Lightweight in assemblies
Scott4tg
SW2006