NX Viewer
NX Viewer
(OP)
Is anybody working with the "NX Viewer" tool in NX v4 or v5?
I have been reading about it, but have only found information on the UGS site. Though I value this information greatly, I would like to hear from the user community on the "Good, Bad & Ugly" of this tool.
I have been reading about it, but have only found information on the UGS site. Though I value this information greatly, I would like to hear from the user community on the "Good, Bad & Ugly" of this tool.





RE: NX Viewer
-Dave
Everything should be designed as simple as possible, but not simpler.
RE: NX Viewer
RE: NX Viewer
Jason
UG NX2.02.2 on Win2000 SP3
UG NX4.01.0 on Win2000 SP3
SolidWorks 2007 SP3.1 on WinXP SP2
RE: NX Viewer
I don't know about earlier versions, but NX5 came with the viewer, but either there is an issue with my licensing or you need to purchase a license for it to run. I get a license error message when trying to run the viewer.
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
RE: NX Viewer
Jason
UG NX2.02.2 on Win2000 SP3
UG NX4.01.0 on Win2000 SP3
SolidWorks 2007 SP3.1 on WinXP SP2
RE: NX Viewer
I'm not sure about NX5, but in NX3 or 4, when the Viewer first came out, you could only view with it. No plotting, or printing, which would be nice features to have for the non-NX user(s). I was looking into it for the purchasing dept, so they could make prints to order parts, without having to interrupt the designers.
-Dave
Everything should be designed as simple as possible, but not simpler.
RE: NX Viewer
Jason
UG NX2.02.2 on Win2000 SP3
UG NX4.01.0 on Win2000 SP3
SolidWorks 2007 SP3.1 on WinXP SP2