Routing - Design Library Defaults to Flanges
Routing - Design Library Defaults to Flanges
(OP)
When mousing over on "create a new route" a message pops up that states to drag and drop a connector or flange to start the route. When this button is selected the design library then opens to a flange folder.
Is there a way to change the folder that opens by default. I would like to have fitting options in addition to flanges that would start a route.
Is there a way to change the folder that opens by default. I would like to have fitting options in addition to flanges that would start a route.






RE: Routing - Design Library Defaults to Flanges
Hope that helps.
Dan
www.eltronresearch.com
RE: Routing - Design Library Defaults to Flanges