design table in cat assembly
design table in cat assembly
(OP)
hey
I have 2 parts with designtables (DT) that i want to put in an assembly, i need to know how i can chose the different configurations off the parts in the DT of the assembly.
Can anyone help ?
I have 2 parts with designtables (DT) that i want to put in an assembly, i need to know how i can chose the different configurations off the parts in the DT of the assembly.
Can anyone help ?





RE: design table in cat assembly
I don't think that you can do this without the PKT license.
I had the same issue awhile back.
-----------------------------------------------------------
Catia Design|Catia Design News|Catia V5 blog
RE: design table in cat assembly
If so when you add your assembly level DT
Just add the Configuration paramter form each table.
It will look something like
Part1\Relations\DesignTable.1\Configuration
Regards
Nev