Mesh Controls
Mesh Controls
(OP)
Dear All,
I am new at Hypermesh, but not new at FEA. Right now as pre- processor I use FEMAP, but the import 3D options are not good.
I have tried Hepermesh and so far it imports with no problems. now I would like to create a MESH COntrol groups, so I could refine the mesh where it is need and leave course in other places.
Could you explain me how to do that? I have looked in the manual and I could not figure that out.
Thanks
I am new at Hypermesh, but not new at FEA. Right now as pre- processor I use FEMAP, but the import 3D options are not good.
I have tried Hepermesh and so far it imports with no problems. now I would like to create a MESH COntrol groups, so I could refine the mesh where it is need and leave course in other places.
Could you explain me how to do that? I have looked in the manual and I could not figure that out.
Thanks





RE: Mesh Controls
Cheers
Greg Locock
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.