Total weight in an assy
Total weight in an assy
(OP)
Is there a callout command for total weight in an assy?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Total weight in an assy
huh? In a draft it's %{Mass|R1} ... in an .asm you cann
use it too or obtain it from Inspect --> Phys. Properties
dy
RE: Total weight in an assy
RE: Total weight in an assy
this could be caused by some parts that don't have their material set. In Physical properties these parts get a 'standard' density. I assume this will not be so in reports.
IJsbrand
RE: Total weight in an assy
Thanks again,
Lumpy