Find Tool
Find Tool
(OP)
When I try to use the Find Tool in an R11 assy to search for a component, it acts like its searching but never gives me any feedback.
I can test the find tool by looking for something I know is there and I know where it is. When I do the search it will highlight the component in the browser. Only problem is... if I don't know where a item is I'll never find it in a large assembly.
What am I missing? Surely this tool works better than this.
I can test the find tool by looking for something I know is there and I know where it is. When I do the search it will highlight the component in the browser. Only problem is... if I don't know where a item is I'll never find it in a large assembly.
What am I missing? Surely this tool works better than this.





RE: Find Tool
Also, you can right-click on the component in the tree and click on "Isolate." This will turn visibility off on EVERYTHING in the assembly except for the component in question.
BTW, if you want to find the part in the browser from the assembly, right-click on the model of the component and click on "Find in Browser."
RE: Find Tool
David
RE: Find Tool
Thanks for the replies everyone.
RE: Find Tool
Incidently, what error is it giving you?