Using Jack?
Using Jack?
(OP)
ok on the UGS website they have all sorts of stuff about jack and human performance stuff. i know in the install it has UG_Jack installed and i think we have the entire advanced design licence so i would think we can access it.
id really like to dabble in this aspect of it to see what we can all do with it, can anybody point me in the direction of where to go to find the program in NX or is it a totally seperate program?
any help would be good.
--JT
id really like to dabble in this aspect of it to see what we can all do with it, can anybody point me in the direction of where to go to find the program in NX or is it a totally seperate program?
any help would be good.
--JT





RE: Using Jack?
Also note that there are non-NX based versions called Jack and Vis Jack, for use outside of NX or when dealing with data from non-NX CAD systems. There are also human modeling products for use in designing virtual factories.
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
UGS Corp
Cypress, CA
http://www.ugs.com
http://www.plmworld.org/museum/