What is the Best Stack Up Analysis Book Out There??
What is the Best Stack Up Analysis Book Out There??
(OP)
I am committed to develop a seminar on tolerance stack-ups and the book I have really doesn't cut it. I found that going through the book did not reflect the impact of profile tolerancing, resultant condition on wall thickness, burr (or edge condition) impact, datum selection, etc. There was quite of bit of adding up the USLs but nothing really meaty.
Can any of the Designers out there recommend a book on tolerance stacks?
Thanks Guys (and ladies too)
Can any of the Designers out there recommend a book on tolerance stacks?
Thanks Guys (and ladies too)
Dave D.
www.qmsi.ca





RE: What is the Best Stack Up Analysis Book Out There??
RE: What is the Best Stack Up Analysis Book Out There??
or
Geometric Tolerancing Applications with Stacks Workbook, includes solutions - $46.00 ea
Both are by Al Neuman, Technical Consultants Inc. and may be purchased at: http://www.geotol.com/textmaterials.htm
GDT_GUY
RE: What is the Best Stack Up Analysis Book Out There??
Don't know if you know, but these are the recommended texts for CATERPILLAR
Kevin Hammond
Mechanical Design Engineer
Derbyshire, UK
RE: What is the Best Stack Up Analysis Book Out There??
Looks like the one from Al Neuman is the way to go. It has to be better than the one I have now.
Dave D.
www.qmsi.ca
RE: What is the Best Stack Up Analysis Book Out There??
9. Traditional approaches to analyzing mechanical tolerance stacks
11. Predicting assembly quality (Six Sigma methodologies to optimize tolerances)
12. Multi-dimensional tolerance analysis (manual method)
13. Multi-dimensional tolerance analysis (automated method)
14. Minimum-cost tolerance allocation
...and some more specific chapters on pinned interfaces and fixed & floating fasteners.
RE: What is the Best Stack Up Analysis Book Out There??
Tunalover