Drawing Formats
Drawing Formats
(OP)
Guys,
I posted this problem before, please see thread554-146326. I still haven't resolved it. It's an ongoing 'pain in the @~'#'.
I basically have a problem with loading formats. Enteties created with the sketch tool are lost when I re-open a drawing. These were loading fine initially. The table entities and text within are fine when re-opened.
Any suggestions welcome. I have tried alll the suggestions in the initial format.
I'm loosing the Third Angle Symbol which is the biggest issue. If I re-load the format, everything comes back in.
i.e File / page set up.
Any suggestion welcome.
Speedy
I posted this problem before, please see thread554-146326. I still haven't resolved it. It's an ongoing 'pain in the @~'#'.
I basically have a problem with loading formats. Enteties created with the sketch tool are lost when I re-open a drawing. These were loading fine initially. The table entities and text within are fine when re-opened.
Any suggestions welcome. I have tried alll the suggestions in the initial format.
I'm loosing the Third Angle Symbol which is the biggest issue. If I re-load the format, everything comes back in.
i.e File / page set up.
Any suggestion welcome.
Speedy





RE: Drawing Formats
Examining and trying to use one may help.
RE: Drawing Formats
and yes, FORMAT_SETUP_FILE is a .dtl specific for the creation of formats in format mode.
Ed Lee
Sr. Designer
H2Gen
Alexandria, VA