Taking a break...
Taking a break...
(OP)
Just so you don't think I've given up on this forum, note that I'll be 'off-line' as it were for the next several weeks, perhaps longer. I go in for shoulder surgery (my right shoulder and I'm right-handed) tomorrow morning and will be off for at least 4 weeks and perhaps longer (I know I won't be allowed to drive for at least 6 weeks). Granted, eventually I'll be able to work from home, but even then I suspect that it will be a couple of weeks before I'll be able to use my right-hand enough to make it worthwhile even trying to login.
Anyway, wish me luck and see you all again in a few weeks.
Anyway, wish me luck and see you all again in a few weeks.
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
UGS Corp
Cypress, CA
http://www.ugs.com
http://www.plmworld.org/museum/





RE: Taking a break...
Mik Doms
Foundry Engineer
Allard-Europe
Flanders
RE: Taking a break...
Justin Ackley
Designer
jackley@gmail.com
RE: Taking a break...
(How's that Indian injury, anyway?)
RE: Taking a break...
_____________________________________
Complex problems have simple, easy-to-understand, wrong answers.
_________________
PI Penkov
CAM Programmer
Non-standard Equipment Designer