Runtime error when starting UG NX3
Runtime error when starting UG NX3
(OP)
Just developed a problem when starting up UG. The splash screen come up the I get this Runtime error
This application has requested the runtime to terminate in an unusual way.
Any ideas?
Thanks in advance.
This application has requested the runtime to terminate in an unusual way.
Any ideas?
Thanks in advance.





RE: Runtime error when starting UG NX3
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
UGS Corp
Cypress, CA
http://www.ugs.com
RE: Runtime error when starting UG NX3
Not sure if this helps. I think I installed a couple diffrent autocad file viewers and have since removed them.
RE: Runtime error when starting UG NX3
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
UGS Corp
Cypress, CA
http://www.ugs.com
RE: Runtime error when starting UG NX3
RE: Runtime error when starting UG NX3
RE: Runtime error when starting UG NX3
RE: Runtime error when starting UG NX3
RE: Runtime error when starting UG NX3
Paul Phillips
Specialty Engineered Automation
http://www.sea4ug.com