How to Get a Wrap Feature to Show up on Drw
How to Get a Wrap Feature to Show up on Drw
(OP)
I have a curved surface where I used the Wrap feature to deboss some letters onto it. These letters do not show up on the drawing file for this part. Does anyone know how to make these letters show up on the drawing?
Thanks
Thanks






RE: How to Get a Wrap Feature to Show up on Drw
Does it show when the drawing view is in Shaded with edges mode?
RE: How to Get a Wrap Feature to Show up on Drw
Sorry, I just checked the wrap feature in the part and I had it on scribe instead of Deboss.
Thanks