Shut off face in a mold.
Shut off face in a mold.
(OP)
Hi I am new to mold design, because I am new to moulded parts.
I have designed a clip into an injection moulding.
The access hole to eliminate the undercut, has its own function, and is not a silhouette of the clip. I was not surprised that SWX could not automatically create a core and cavity, because the shut off face is not defined by anything.
Any tips or tricks out there?
Colin
I have designed a clip into an injection moulding.
The access hole to eliminate the undercut, has its own function, and is not a silhouette of the clip. I was not surprised that SWX could not automatically create a core and cavity, because the shut off face is not defined by anything.
Any tips or tricks out there?
Colin






RE: Shut off face in a mold.
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376
RE: Shut off face in a mold.
I will go through your example.
Colin
RE: Shut off face in a mold.
http
htt
http:/
Chris
SolidWorks 06 5.1/PDMWorks 06
AutoCAD 06
ctopher's home (updated 10-27-06)