What's new 2006 ...
What's new 2006 ...
(OP)
Yes, I am trying to catch up on 2006 - just now have a bit "spare" time to do this ...
Anyway, page 8-5 "What's new" manual says:
I have a sheet metal part open and nowhere I can find the selection mentionned in 2. above "select Sheet Metal"

Can anybody help ?
Anyway, page 8-5 "What's new" manual says:
Quote:
To set flat pattern colors:
1. ....
2. On the Document Properties tab, select Sheet Metal
I have a sheet metal part open and nowhere I can find the selection mentionned in 2. above "select Sheet Metal"
Can anybody help ?






RE: What's new 2006 ...
1. With a Drawing Document open click options (Standard Toolbar) or Tools->Options.
You need to open a drawing since document options are specific to the type of document that you have active.
Todd
RE: What's new 2006 ...