×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Ordinate---Alternate...

Ordinate---Alternate...

Ordinate---Alternate...

(OP)
After about 30 minutes of scratching my head, I've come to a conclusion that in multiple alternate positions you can't Ordinate to them.... Has this been fixed in 07? Or am I just wrong?

Go Honda!

RE: Ordinate---Alternate...

You should be able to.

Perhaps try sketching a point or line, constrain to edge or vertex, and dimension to that.

RE: Ordinate---Alternate...

(OP)
I tried that too... I put a point in the middle of a circle, and tried to constrain a vertical and horizontal line to it, SW obviously didn't like it so it died... i found a way around the solution, our deliverable document is paper so I faked it in... Thanks though....

Go Honda!

RE: Ordinate---Alternate...

(OP)
Does this get fixed for SW 2007?

Go Honda!

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources