My program does not converge
My program does not converge
(OP)
Hi!!!
someone can help me please?
When I used the specific heat C in a transient thermal analysis, it converges correctly. But when I replace C by the corresponding values of ENTH, the program does not converge any more!!! Is there a particular command which I must use to avoid not-convergence?
here some commands witch i used:
ANTYPE,TRANS
NROPT,FULL
SOLCONTROL,ON
OUTRES,ALL,LAST
AUTOTS,ON
but it does not converge
Thank’s in advance
Barha
someone can help me please?
When I used the specific heat C in a transient thermal analysis, it converges correctly. But when I replace C by the corresponding values of ENTH, the program does not converge any more!!! Is there a particular command which I must use to avoid not-convergence?
here some commands witch i used:
ANTYPE,TRANS
NROPT,FULL
SOLCONTROL,ON
OUTRES,ALL,LAST
AUTOTS,ON
but it does not converge
Thank’s in advance
Barha





RE: My program does not converge
-Brian
RE: My program does not converge
RE: My program does not converge
thank's
Barha