name a curve spline in NX4 journal
name a curve spline in NX4 journal
(OP)
Hi everyone
I created 2 splines thru points with a journal file
how can i give them "Names" to use in selecting them later
to make a mesh surface in journal NX4
any help would be greatly appreciated
Thanks
Rick Dufour
Senior Programmer
Rich Technology Int.
I created 2 splines thru points with a journal file
how can i give them "Names" to use in selecting them later
to make a mesh surface in journal NX4
any help would be greatly appreciated
Thanks
Rick Dufour
Senior Programmer
Rich Technology Int.





RE: name a curve spline in NX4 journal