Floworks V2006 in assembly mode?
Floworks V2006 in assembly mode?
(OP)
Hi,
Kinda new to floworks...
I have an electronic enclosure assy, and I was told to simulate various flow locations within the enclosure.
Do I have to model enclosure as single part to apply simulation to it? Is it possible to simulate right on the assembly, not just part?
Any pointer would be greatly appreciated.
Kinda new to floworks...
I have an electronic enclosure assy, and I was told to simulate various flow locations within the enclosure.
Do I have to model enclosure as single part to apply simulation to it? Is it possible to simulate right on the assembly, not just part?
Any pointer would be greatly appreciated.






RE: Floworks V2006 in assembly mode?
you can leave the assembly as it is, the only condition being that it must be effectively "closed" from FW point of view (i.e. sometimes some face tangencies are not correctly recognized and so the enclosed volume is seen as "open").
Regards