Drawing a cross section
Drawing a cross section
(OP)
I have AutoCAD 2005 and I need to design cross sections of rockery walls. My question is: Does the regular old AutoCAD 2005 have that capibility, and if so how? If not, what program do I need in order to do so?
We get sent grading plans on a regular basis and an engineer here wants me to start doing cross sections thru the rockery walls in order to see the slopes, elevations, and so forth. Any suggestions would be appreciated.
We get sent grading plans on a regular basis and an engineer here wants me to start doing cross sections thru the rockery walls in order to see the slopes, elevations, and so forth. Any suggestions would be appreciated.





RE: Drawing a cross section
If there aren't too many, you could draw the x-sections by hand.
RE: Drawing a cross section
RE: Drawing a cross section
RE: Drawing a cross section
RE: Drawing a cross section
RE: Drawing a cross section
But I know I did it. Read Help for 3d rotate command.
Engineering is the practice of the art of science - Steve
RE: Drawing a cross section
p.s., I am not fuddy-duddy to not realize that computers are great - saved my butt on determining quantities of a road curve straighening - but I had sketched in the alignment and estimated toes by hand - then gave it to the surveyor to pretty it up.