Flate State In WF2
Flate State In WF2
(OP)
Hi.
I used to have a mapkey in sheetmetal 2001 to produce a flat patteren of a part as an instance ensuring that the unbend was the last featurn in the flat pattern instance.
Where is this in Wildfire 2?, Flat pattern just flattens the part in the generic.
AD
I used to have a mapkey in sheetmetal 2001 to produce a flat patteren of a part as an instance ensuring that the unbend was the last featurn in the flat pattern instance.
Where is this in Wildfire 2?, Flat pattern just flattens the part in the generic.
AD





RE: Flate State In WF2
Edit - Setup - Flat State
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
Sr IS Technologist
L-3 Communications
RE: Flate State In WF2
http://www.sprdesign.com
http://www.3dlogix.com