radius compensation on cincinnati milacron
radius compensation on cincinnati milacron
(OP)
i have a cincinnati milacron turning centre, hawk 150
with A-2100 contoller. When using radius compensation i can use any offset up to 0.4, but anything after that eg:(0.8/1.2) it seems that the machine does not except theses offsets.
has anyone experienced this problem, is it a machine parameter that can be set or changed?
cheers





RE: radius compensation on cincinnati milacron
http:/
RE: radius compensation on cincinnati milacron
i've registered on that site, unfortunately i have to wait for administration to sort me out before i can enter any forum. looks like it could be very helpful.
thanks mate