Rack and pinion mates
Rack and pinion mates
(OP)
Sorry if this has been covered before...
I am using SW 2006 and am trying to mate/drive a rack and pinion I have modelled. I notice in the 'Whats New' of SW2007 there is a specific rack and pinion mate but I was hoping that this is achievable in SW06 maybe through use of the gear mates(?) but I have had no luck. Any help greatly appreciated.
Thanks
I am using SW 2006 and am trying to mate/drive a rack and pinion I have modelled. I notice in the 'Whats New' of SW2007 there is a specific rack and pinion mate but I was hoping that this is achievable in SW06 maybe through use of the gear mates(?) but I have had no luck. Any help greatly appreciated.
Thanks






RE: Rack and pinion mates
Scott
RE: Rack and pinion mates
RE: Rack and pinion mates
Eric
RE: Rack and pinion mates
I saw it at the rollout yesterday.
Chris
Systems Analyst, I.S.
SolidWorks 06 4.1/PDMWorks 06
AutoCAD 06
ctopher's home (updated 06-21-06)