roughness
roughness
(OP)
i want on a plate to determine the roughness
any one know how to do this
also i want to create a surface like dimple´s what you find on a golf ball
but what ever i try cannot get it done it make´s me grazy
any good sugestions??
any one know how to do this
also i want to create a surface like dimple´s what you find on a golf ball
but what ever i try cannot get it done it make´s me grazy
any good sugestions??





RE: roughness
Go to Part Design -> split -> choose the patterned surface.
Since its a plate (flat?) this would be easy enough. For a moving surface I'm not really sure...
RE: roughness
so let say 1 mm steel plate a dimple if 1 mm also with diameter of 10 mm
just cannot get it done in part design
and yes it also have to rotate
RE: roughness
have 2 bodies : first one with 1mm plate, seconde one with a 1mm thick (outside) 10mm radius half sphere.
then make boolean trim.... and fillet if needed
indocti discant et ament meminisse periti