Control Points on surfacing
Control Points on surfacing
(OP)
Hi all,
Can someone point me a direction how to set control points on surfacing (such as Blend boundaries)? I checked my textbook, & stuff, but didn't say too much on it.
Thanks in advance.
engmechs
Can someone point me a direction how to set control points on surfacing (such as Blend boundaries)? I checked my textbook, & stuff, but didn't say too much on it.
Thanks in advance.
engmechs





RE: Control Points on surfacing
http://www.ptc.com/cs/cs_24/howto/suf55/suf55.htm
The PTC Knowledge Base is pretty useful, and is always the first place where I look if I have any problems with Pro/E:
http://www.ptc.com/appserver/cs/search/search.jsp
RE: Control Points on surfacing
I can't access the first website... lost my password .... can you send this page to me?
Regards,
engmechs