Air duct maker
Air duct maker
(OP)
Hi,
I am looking into the process of making sheet metal air ducts. Does anyone have experience and/or knowledge about a sheet metal duct production process or even something like an 'air duct maker'?
Also I am looking at plasma and laser cutters (for the sheet metal), but I worry that the heat from the plasma cutter might affect the galvanised sheet metal. Any thoughts on that?
Regards,
Gert
I am looking into the process of making sheet metal air ducts. Does anyone have experience and/or knowledge about a sheet metal duct production process or even something like an 'air duct maker'?
Also I am looking at plasma and laser cutters (for the sheet metal), but I worry that the heat from the plasma cutter might affect the galvanised sheet metal. Any thoughts on that?
Regards,
Gert





RE: Air duct maker
Here is a useful site for lot's of things: http://www.mosquitonet.com/~gcn/hvac.htm
Go to this site and then under organizations go to SMACNA (Sheet metal and Airmoving Contractors National Association)
Another site is www.sheetmetal-iti.org.