aligning broken views
aligning broken views
(OP)
Is it possible to align break lines in adjacent drawing views?
I have a drawing of a long part with three holes in the top view. I put in a couple of vertical breaks, so I can fit the part on the sheet and still see the holes. Now I want to break the side view and position it so that the ends of the part line up, view to view. I don’t see how to do this other than trial and error.
Any suggestions?
I have a drawing of a long part with three holes in the top view. I put in a couple of vertical breaks, so I can fit the part on the sheet and still see the holes. Now I want to break the side view and position it so that the ends of the part line up, view to view. I don’t see how to do this other than trial and error.
Any suggestions?






RE: aligning broken views
Dave Gowans
RE: aligning broken views
RE: aligning broken views
Both methods work great.