Eurotherm 590 Fault
Eurotherm 590 Fault
(OP)
hello problem magnets
I have a Eurotherm 590 drive which when the run command is active the drive LCD display goes blank and there is no output to the motor.
Has anyone come across this problem ?
If so can you advise
thanx in advance
grommit
I have a Eurotherm 590 drive which when the run command is active the drive LCD display goes blank and there is no output to the motor.
Has anyone come across this problem ?
If so can you advise
thanx in advance
grommit





RE: Eurotherm 590 Fault
Gunnar Englund
www.gke.org
RE: Eurotherm 590 Fault
hi skogsgurra
i am flying out to see this drive in a couple of days
the people who maintain the equipment dont have any experience of this type.
I will carry out the obvious when i get there but i posted just in case this fault had raised its head before to give me a heads up before i arrive on site
thanx for your reply
RE: Eurotherm 590 Fault
I have had some of these just dying. Was something in the PSU. But they never healed themselves.
Gunnar Englund
www.gke.org
RE: Eurotherm 590 Fault
Yep i think youre right.
Im taking a 590P (newer replacement) with me just in case.
Great forum btw.
Dave