HELP!
HELP!
(OP)
I get this message when running:
The plasticity/creep/connector friction algorithm did not converge at 322 points
What does this mean??
The plasticity/creep/connector friction algorithm did not converge at 322 points
What does this mean??





RE: HELP!
The error message that the plasticity/../ friction algorithm didn't converge at 322 points could mean anything. You'll have to give mroe information, besides HELP.
corus
RE: HELP!
when I run the model trying to capture the the cracking response of my concrete slab I get this message and I don“t know what this means.
Perhaps it has do with that the first crack appears and abaqus can not calculate it or what do you think????
RE: HELP!
A fixed number of interations is imposed to these algorithms to be performed until the specified degree of accuracy is obtained. If this accuracy is not obtained within those iterations ABAQUS will stop the computation and state that the algorithm does not converge.
This may happen if you use for example a non-monotonic stress-strain response curve for the plastic behaviour of the material.
You could try to confine the maximum time increment to a smaller value.