Assembly Symmetry - Threads aren't mirrored
Assembly Symmetry - Threads aren't mirrored
(OP)
I have an issue, where I created an associative Asemmbly Symmetry of a part which had tapped holes. The geometric features (ie: holes) were succesfully mirrored, but the thread features weren't (and as such, don't show up in Drafting, Thread Analysis, etc).
Is this how it's supposed to act, or am I doing something wrong?
How do you do an Assembly Symmetry and mirror data like threads, along with the geometry?
Is this how it's supposed to act, or am I doing something wrong?
How do you do an Assembly Symmetry and mirror data like threads, along with the geometry?





RE: Assembly Symmetry - Threads aren't mirrored
Derek
RE: Assembly Symmetry - Threads aren't mirrored
RE: Assembly Symmetry - Threads aren't mirrored
Regards,
Derek
RE: Assembly Symmetry - Threads aren't mirrored
Or possibly "fake" the threads in Drafting by assigning a thread callout to the holes?
RE: Assembly Symmetry - Threads aren't mirrored
RE: Assembly Symmetry - Threads aren't mirrored
Regards,
Derek