Cold rolling of splines acc. to DIN 5480 on a GROB machine
Cold rolling of splines acc. to DIN 5480 on a GROB machine
(OP)
Hi all,
does anybody have experience with cold rolling of a spline acc. to DIN 5480 standard on a GROB machine? Is it possible? There are special standards for cold rolled splines though.
does anybody have experience with cold rolling of a spline acc. to DIN 5480 standard on a GROB machine? Is it possible? There are special standards for cold rolled splines though.





RE: Cold rolling of splines acc. to DIN 5480 on a GROB machine
DIN 5480, part1, page 2, paragraph 3.2:
"Pressure angles of 37.5 and 45 degrees are preferred for production by cold rolling....."
RE: Cold rolling of splines acc. to DIN 5480 on a GROB machine