Contact/Gap information in Cosmos
Contact/Gap information in Cosmos
(OP)
How to set contact/gap in solidworks cosmos 2006. There are so many options/choices in this, I am not sure how to proceed. i.e. global,contact, bonded, pentration etc. Is there any internet site gives information on this topic.






RE: Contact/Gap information in Cosmos
you're lucky the contact options in CosmosWorks are really really basic if compared to other FE softwares !
The best place to start is the Help file.
Please understand that your question is so large that it would be almost impossible to adequately reply here.
Have a look at the CosmosWorks manual, then repost here with more specific questions about some points you still don't understand. In other words: please "guide" us about exactly what gets you confused...
Regards