Stick Font
Stick Font
(OP)
Does anyone know of any way to get SolidWorks to do stick font (for easy translation into MasterCAM)?
Just for clarification, stick font uses only straight lines. Think of an old school calculator and the way it displayed numbers and letters.
Thanks
Just for clarification, stick font uses only straight lines. Think of an old school calculator and the way it displayed numbers and letters.
Thanks






RE: Stick Font
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376
RE: Stick Font
http://
Mastercam has Text 3D which you may be able to use.
http://ww
http:
See also Single Line Font thread559-156322
http://www.dafont.com/
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091
RE: Stick Font