Conversion issue from Rhino
Conversion issue from Rhino
(OP)
Hello all.
Has anyone had any success importing step or sat files with Inventor 10 that were generated with Rhinoceros 3.0?
We are receiving about 2% of the 3D model translated this way.
Any tips?
Thanks in advance.
tg
Has anyone had any success importing step or sat files with Inventor 10 that were generated with Rhinoceros 3.0?
We are receiving about 2% of the 3D model translated this way.
Any tips?
Thanks in advance.
tg





RE: Conversion issue from Rhino