mesh and mesh control issues
mesh and mesh control issues
(OP)
Hello,
I am having the following problems with meshing an assembly in cosmosworks 2005:
1. When viewing failure diagnostics, while reviewing the part that failed, cosmos will point me to an edge on a different part.
2. After applying a control to a part, and leaving the global mesh settings the same, parts that previously meshed before no longer mesh.
What could be going wrong here?
Thanks in Advance,
Adrian
I am having the following problems with meshing an assembly in cosmosworks 2005:
1. When viewing failure diagnostics, while reviewing the part that failed, cosmos will point me to an edge on a different part.
2. After applying a control to a part, and leaving the global mesh settings the same, parts that previously meshed before no longer mesh.
What could be going wrong here?
Thanks in Advance,
Adrian






RE: mesh and mesh control issues
Chris
Systems Analyst, I.S.
SolidWorks 06 4.1/PDMWorks 06
AutoCAD 06
ctopher's home (updated 06-21-06)
RE: mesh and mesh control issues