what are some ways to show a radius bend on sheet metal?
what are some ways to show a radius bend on sheet metal?
(OP)
Im trying to do a spec drawing on a product with a radius bend on it. I tried using sketch bend, edge flange, as well as trying to rip after modeling a shell model. I know this process isn't common in sheetmetal but this is an exception. If any one knows the trick, please share.






RE: what are some ways to show a radius bend on sheet metal?
If so you cannot do that in Sheet Metal in any SW version prior to SW07. SW07 does have that ability though.
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091
RE: what are some ways to show a radius bend on sheet metal?
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091