Steam Trap
Steam Trap
(OP)
Hello every one!
please help,
We need to purchase the Steam Trap for heat exchanger, if some one have any Idea of what type is more suitable?
service: LP Steam & Condensate
Line: LC2020-1" (1S1)
press. & Temp. 300#
trim material: S.S.
body m: C.S.
mesh Size: 1/32 holes/S.S.
Thanx
Moury
please help,
We need to purchase the Steam Trap for heat exchanger, if some one have any Idea of what type is more suitable?
service: LP Steam & Condensate
Line: LC2020-1" (1S1)
press. & Temp. 300#
trim material: S.S.
body m: C.S.
mesh Size: 1/32 holes/S.S.
Thanx
Moury





RE: Steam Trap
Tell them all of your conditions and see what you get
http://
Regards
RE: Steam Trap
Common traps for this service would be an inverted bucket or a float type trap. The selection would prefer on your preferences, operating pressures (normal versus maximum) and required capacity. An open bucket is also a possibility but these are much less common than an inverted bucket.