COM143 Software For CP1434 configuration.
COM143 Software For CP1434 configuration.
(OP)
Can anyone direct me to a source for the above software? It's needed to configure a comms processor, CP143, in a Siemens S5 135 Rack to enable comms to a 928 Processor in the same rack.
I also believe a comms cable is needed so can you confirm the type required?
Siemens do not sell it anymore.
Thanks,
Terry.
I also believe a comms cable is needed so can you confirm the type required?
Siemens do not sell it anymore.
Thanks,
Terry.





RE: COM143 Software For CP1434 configuration.
Have you managed to locate a copy of COM143 yet?
What do you intend to use to program the CP143, a PC or a Siemens PG programmer?
Kevin