Name sketch dimension on creation switch?
Name sketch dimension on creation switch?
(OP)
I was wondering if there was a switch similar to the one in the featuremanager options (name feature on creation), but then for sketch dimensions.
This would make the time needed for giving sketch dimensions sensible names (for use in design tables) much faster.
This would make the time needed for giving sketch dimensions sensible names (for use in design tables) much faster.
Stefan Hamminga
EngIT Solutions
CSWP/Mechanical designer/AI student






RE: Name sketch dimension on creation switch?
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091