split flow
split flow
(OP)
I am planning of spltiing the flow of oil,water,gas into two heater treaters and am looking for the best way to accurately control and quantify the split flow. Any suggestions?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: split flow
RE: split flow
RE: split flow
sshep, the mixed phase will consist of a 70% water and 30% oil emulsion and very little gas.
RE: split flow
If the distance is far (or other reasons make the manual valve adjustments from the control room), also consider an I/P with HIC in the DCS for the manual valve.
RE: split flow
The three way valve simply acts as a diverter to split the flow. I like three ways valves for this purpose. The only downside can be cost for large pipe sizes- a three way valve requires more metal than an equivalent line valve.
best wishes,
sshep
RE: split flow
RE: split flow
two phase flow is dificult to control, so try symmetrical lines.
regards,
roker
RE: split flow
Mike Halloran
Pembroke Pines, FL, USA
RE: split flow
RE: split flow
RE: split flow
RE: split flow
Mike Halloran
Pembroke Pines, FL, USA