Helix with a Bend
Helix with a Bend
(OP)
Good afternoon, I have a helix, to make a spring. On each end of the helix I have a fully defined radius, to make it look like I bent the spring. I attached a circle to the first radius, again fully defined, and tried to sweep the entire thing, but it only went as far as the first radius. Now if this matters, the two radiuses on the ends of the helix were grey in color. What is wrong with what I am tring to do? I did use pierce when ever possible. Any suggestions on how to sweep the entire thing? Thank you in advance for any assistance.






RE: Helix with a Bend
Chris
Systems Analyst, I.S.
SolidWorks Pro 06/PDMWorks 06
AutoCAD 06
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716
RE: Helix with a Bend
RE: Helix with a Bend
RE: Helix with a Bend
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091
RE: Helix with a Bend