decohesion - traction separation in abaqus
decohesion - traction separation in abaqus
(OP)
Could any one please guide me how can I simulate the debonding behaviour of the two cylinder type models in ABAQUS. It will be a life saving help from you. Thank you!!!!
Regards,
Regards,





RE: decohesion - traction separation in abaqus
I have only started familiarising with abaqus, but i need to gain some knowledge on create a cohesive interface between two layers to look at debonding in this region. I have seen you name crop up many times in these forum, I am new here. if you have msn please could you add me - muffinfubu @ hotmail.com .
thanks
muffin
RE: decohesion - traction separation in abaqus
http://www