Problem with Sketch Picture Wrap
Problem with Sketch Picture Wrap
(OP)
I'm having problem with wrapping sketch picture. What I'm trying to do is to place the company's logo on an area of a part. This area is curved like a semi-circle. Please what do I need to do?






RE: Problem with Sketch Picture Wrap
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
Solidworks 2006 SP0.0
RE: Problem with Sketch Picture Wrap
If your company logo is simple enough you can cut the logo into the curved surface.
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
Solidworks 2006 SP0.0