Tool Box
Tool Box
(OP)
Good Morning,
When I put a tool box component, mainly screws, into an assembly. It has the wrong description in the BOM. Where does it pull this info from. I would like to go and fix it.
Thanks
Chris Tellers
When I put a tool box component, mainly screws, into an assembly. It has the wrong description in the BOM. Where does it pull this info from. I would like to go and fix it.
Thanks
Chris Tellers






RE: Tool Box
There you need to click the "Edit" button. You can add a custom part number and custom description to the toolbox fastener.
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
Solidworks 2006 SP0.0
RE: Tool Box
Chris
RE: Tool Box
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376
RE: Tool Box
Chris
RE: Tool Box
Make sure you change the status for that toolbox part back to read-only status after making the change.
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
Solidworks 2006 SP0.0
RE: Tool Box
Chris
RE: Tool Box
Eric
RE: Tool Box
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376