Pro-Engineer to Solidworks
Pro-Engineer to Solidworks
(OP)
Hello Fellow PTC Users,
I am really starting to get hit up about Solidworks.... I have customers who are now demanding direct translations of our Pro-e tool design to be converted into Solidworks, with model trees. Does anyne know if 3.0 will do this now or is it once again a ptc rumor?
Thank you in advance!
I am really starting to get hit up about Solidworks.... I have customers who are now demanding direct translations of our Pro-e tool design to be converted into Solidworks, with model trees. Does anyne know if 3.0 will do this now or is it once again a ptc rumor?
Thank you in advance!





RE: Pro-Engineer to Solidworks
Here is an article I posted in the SWx forum regarding the same topic. The two kernals are different and have different accuracies.
ht
Best Regards,
Heckler
Sr. Mechanical Engineer
SW2005 SP 5.0 & Pro/E 2001
Dell Precision 370
P4 3.6 GHz, 1GB RAM
XP Pro SP2.0
NVIDIA Quadro FX 1400
o
_`\(,_
(_)/ (_)
Never argue with an idiot. They'll bring you down to their level and beat you with experience every time.
RE: Pro-Engineer to Solidworks
Best Regards,
Heckler
Sr. Mechanical Engineer
SW2005 SP 5.0 & Pro/E 2001
Dell Precision 370
P4 3.6 GHz, 1GB RAM
XP Pro SP2.0
NVIDIA Quadro FX 1400
o
_`\(,_
(_)/ (_)
Never argue with an idiot. They'll bring you down to their level and beat you with experience every time.