Repair wave broken link
Repair wave broken link
(OP)
Hi, i d like to know if there is a way to repair a broken link in NX3. In a part i've a wave geometry linker of a sketch that has been broken...(the base sketch is in the top of the assembly).
So, is there a way to repair this broken link, 'cause, i don t want to re build many parts.
Thanks a lot
Bye
So, is there a way to repair this broken link, 'cause, i don t want to re build many parts.
Thanks a lot
Bye





RE: Repair wave broken link
You only have to edit the feature "link sketch" and to re selection the sketch in the parent part.