Importing Cross hatch into a drawing
Importing Cross hatch into a drawing
(OP)
Anyone been able to get this to work?
In our title block, we have the name of the company cross hatched. But when you import it, it removes the cross hatch.
Just wonder if there is a way around this, or it is just one of those things that does not come through onto the drawing.
In our title block, we have the name of the company cross hatched. But when you import it, it removes the cross hatch.
Just wonder if there is a way around this, or it is just one of those things that does not come through onto the drawing.





RE: Importing Cross hatch into a drawing
I couldn't find a direct way to 'explode' the crosshatching, but I only poked about for a few minutes. Maybe someone else has an easier way.
RE: Importing Cross hatch into a drawing
This is very similar to the method I'm familar with, except that the cgm lines of the hatch are brought into a seperate part file, and then the pattern data saved is used in our drawings.
Regards,
SS
CAD should pay for itself, shouldn't it?